12x Resin Models - Birch Trees
INSIDE THIS RESIN BASING BITS PACK
Finally, a tree designed for your infantry! Birch trees are intentionally designed to fit on more bases and in more miniature-basing scenarios. They have narrow trunks, are quite straight, and have fewer exposed branches. Additionally, they're a bit shorter than the other trees so they don't dominate your smaller models, and the multi-trunk bits can be broken apart into even more smaller sections!
- 12x resin 3D printed basing bits
- 6x taller versions 50-60mm in height
- 6x smaller versions 30-45mm in height
- in a variety of sizes and orientations that work on nearly any miniature base
- and are pre-washed and cured with *supports removed.
Resin Safety
SAFETY
Epic Basing basing bits are made from 3D printed resins that may be harmful if ingested. Take normal precautions while handling the resin pieces and avoid contact with your mouth and eyes. After handling, wash hands with mild soap and water.
These packs contain small and sharp parts and are recommended for ages 13+.
RESIN INFO
Material feels soft and rubbery like an elastic band and is noticeably flexible on smaller finer parts. Rubbery texture may feel tacky on larger surface area pieces.
Resin may have a smelly odor upon unpackaging that should fade quickly when left exposed to air.
Preparation & Storage
PREPARATION
Resin pieces are provided fully washed and cured with most supports removed making them almost ready to paint right out of the pack.
Simply inspect the pieces for small detail supports that look like little sticks often over gaps. They can be easily removed with the tip of a hobby knife.
It is recommended to prime the pieces before painting. Primers, paints and any varnishes can all provide layered protection.
STORAGE
Store pieces in containers out of direct sunlight to prevent resin degradation that increases brittleness.